Prior To Installation - Fisher & Paykel 7 Series Installation Manual

Fisher & Paykel is not liable for any damage caused by not following these instructions.
Please read the instructions carefully.
z
Unpack the rangehood.
z
Ensure the voltage (V) and the frequency (Hz) indicated on the rating plate match
z
the voltage and frequency of the installation site.
Check all functions are working.
z
Check that the area behind the installation surface to be drilled is clear of any electrical
z
cables or pipes etc.
The rangehood surfaces can be damaged during installation if grazed or knocked
z
by tools. Please take care to protect the surfaces during installation.
Protect the cooktop surface with cardboard, or the like, to prevent damage
z
occurring whilst the rangehood is being installed above.
Temporarily mark the height of the bottom of the rangehood and the centre of the
z
cooktop on the wall according to the information given in the 'Installation Height' section.
The wall used for mounting the rangehood should have sufficient strength and a
z
flat surface.
A power outlet should be within 750 mm of the rangehood and can either be on the wall,
z
behind the chimney or in the ceiling.

PRIOR TO INSTALLATION

7