Marantz SR7013 Service Manual page 162

Paths to be confirmed Display (Sub Display)
Analog Amp Assign
（Amp Assign :
9 fig.A09
A09:ASSIGN-Z2/3M
ZONE2/ZONE3-
MONO）
Amp Assign
fig.A10a
10 (Amp Assign :
A11:ASSIGN-BiAMP
fig.A10b
BiAMP)
fig.A11a
11 Front Height
A14:FRONT HEIGHT
fig.A11b
12 7.1ch fig.A12
A19: 7.1CH IN
Front Amp ⇒ Sur- fig.A13a
13
A20:F-AMP BACK
round Back fig.A13b
Settings
Input Source : CBL/SAT
Input Mode : Auto
Sound mode : STEREO
Z2 Source : Source
Z3 Source : Source
Amp assign : 7.1ch + ZONE2/3
Floor Layout : 5ch&SB
MAIN ZONE : On
ZONE2 : On
ZONE3 : On
Input Source : CBL/SAT
Input Mode : Auto
Sound mode : MULTI CH STEREO
Amp assign : 7.1ch + BiAMP
Floor Layout : 5ch
Height Sp : 2ch
Dolby Sp : None
Height Layout : Front Height
MAIN ZONE : On
ZONE2 : Off
ZONE3 : Off
Input Source : CBL/SAT
Input Mode : Auto
Sound mode : MULTI CH STEREO
Amp assign : 9.1ch
Floor Layout : 5ch
Height Sp : 4ch
Dolby Sp : None
Height Layout : Top Front & Top Rear
Speaker Select : Floor & Height
MAIN ZONE : On
ZONE2 : Off
ZONE3 : Off
Input Source : CBL/SAT
Input Mode : 7.1Ch In
Amp Assign : 9.1ch
Floor Layout : 5ch&SB
Height Sp : None
Dolby Sp : None
Speaker Config ALL Speaker = Small/SW = Yes(2ch)
Input Source : CBL/SAT
Input Mode : Auto
Sound mode : MULTI CH STEREO
Amp assign : 11.1ch
Height Speakers : 4Height Speakers
Height Layout : Top Front & Top Rear
Pre OUT Channel : Front
Speaker Select : Floor & Height
MAIN ZONE : On
ZONE2 : Off
ZONE3 : Off
162
What to confirm
・ Analog input ⇒ Speaker output (Height2 (ZONE2) L, Height2 (ZONE3) R)
・ Analog input ⇒ Pre OUT output (ZONE2 L/R MONO, ZONE3 L/R MONO)
( b The input source can be switched to any source except CBL/SAT.)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
・Analog input ⇒ Speaker output (Height2 L/R (Top Front))
( b The input source can be switched to any source except CBL/SAT.)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
・Analog input ⇒ Speaker output (Height1 L/R (Top Front), Height2 L/R (Top Front))
・ Analog input ⇒ Pre OUT output (Height1 L/R (Top Front), Height2 L/R (Top Rear))
・ Pre OUT output
( b The input source can be switched to any source except CBL/SAT.)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
・ 7.1ch IN input ⇒ Speaker output (Front L/R, Center, Surround L/R, S.Back L/R)
・ Pre OUT output (Front L/R, Center, Surround L/R, S.Back L/R, Subwoofer1/2)
・ Analog input ⇒ Speaker output (S.Back L/R)
( b The input source can be switched to any source except CBL/SAT.)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)