Marantz SR7013 Service Manual page 142

When the results of check item (3-17.1.) are "78 or
(Detection of 5V is not OK.)
Check the +5V voltage. (HDMI DDC Buffer)
Check item(3-17.3.). Check the +5V voltage.
Does the HDMI Tx [IC431] test point indicate (5V)?
The test points are as follows.
IC431
106pin
YES
HDMI Tx [IC431] is faulty.
Replace with a new device.
Recheck from check item (3.4.)
If it does not work, replace the PCB.
70"
NO
Check for a short circuit in the 5 V line, the
Front HDMI FFC, and the 5 V Switch [IC392].
If there is no problem, the HDMI Tx [IC431] or
the 5 V Switch [IC392] is faulty.
Replace with a new device.
When the results of check item (3-17.2.) are
(Detection of DDC is not OK.)
Check the DDC Line. (HDMI DDC Buffer)
Check item(3-17.4.). Check the DDC line :
Are the "DDCSCK" and "DDCSDA" waveforms for
the HDMI Tx [IC431] signal correct (as shown in the
figure)?
The test points are as follows.
F_CK
F_DA
JK433
HDMI OUT
[F-HDMI]
YES
HDMI Tx [IC431] is faulty.
Replace with a new device.
Recheck from check item (3.4.)
If it does not work, replace the PCB.
142
"00 or 04"
less than 100KHz
5V
5V
This diagram shows an example of the DDC commu-
nication waveform.
-The high level voltage is 5V.
-The frequency of the DDC CLK is 100kHz or less.
Check at each test point.
Voltage scale : 2.0V/div
Time scale : 40us/div
NO
Check for a short circuit in the DDC line and
check the Front HDMI FFC.
If there is no problem, the HDMI DDC Buffer
[IC201] is faulty.
Replace with a new device.