Blade Speed - Grizzly G0555LX Owner's Manual

Table Tilt
The table can be tilted to make angled or beveled
cuts. A simple tilt scale is provided on the trun-
nion for a quick gauge (see Figure 43). For more
accurate results use a protractor.
Tilt Scale
& Pointer
Figure 43. Table tilt controls.
Note: When tilting the table to the left, the positive
stop bolt must be lowered. Be sure to re-adjust it
when returning the table to be perpendicular with
the blade.
To tilt the table:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen both table lock knobs underneath the
table.
3.
Tilt the table to the desired angle, then re-
tighten the lock knobs.
Model G0555LX (Mfd. Since 1/14)
Lock Knob
(1 of 2)

Blade Speed

The Model G0555LX offers blade speeds of 1800
and 3100 FPM. Speed changes are made by re-
positioning the V-belt in different pulley grooves.
Keep in mind, cutting results are not just related
to blade speed. Other factors include: the type of
workpiece, the blade being used for the operation,
and the feed rate.
Use the chart below as a general guide
for which blade speeds to use for various
operations:
Type of Cutting Operation
General Woodworking
Super Dense Hardwood
Fast/Average Feed Rate
Requires Slow Feed Rate
Rough Edges Acceptable
Requires Smooth Edges
Quick, Production Cuts
Detailed, Intricate Cuts
Tool Needed
Hex Wrench 6mm .............................................. 1
To change the blade speed:
1.
DISCONNECT MACHINE FROM POWER!
2.
Open the lower wheel cover, and loosen the
motor mount cap screws shown in Figure 44.
Figure 44. Motor mount cap screws.
Blade Speed
(FPM)
3100
1800
3100
1800
3100
1800
3100
1800
Qty
Motor Mount
Cap Screws
-35-