Asynchronous Serial Ports; Ethernet Ports - Cisco PRP-1= Installation And Configuration Manual

Asynchronous Serial Ports

Ethernet Ports

Note
Hard Disk Drive
Note
OL-11656-01
The PRP has two asynchronous serial ports, the console and auxiliary ports. These
allow you to connect external serial devices to monitor and manage the system.
Both ports use RJ-45 receptacles.
The console port provides a data circuit-terminating equipment (DCE) interface
for connecting a console terminal. The auxiliary port provides a data terminal
equipment (DTE) interface and supports flow control. It is often used to connect
a modem, a channel service unit (CSU), or other optional equipment for Telnet
management.
The PRP includes two 10/100 Mbps Ethernet ports, each using an 8-pin RJ-45
receptacle for either IEEE 802.3 10BASE-T (10 Mbps) or IEEE 802.3u
100BASE-TX (100 Mbps) connections.
The PRP-2 includes a 10/100/1000 Mbps Ethernet port, which uses the above
connections and also a 802.3 Gigabit Ethernet connection.
The transmission speed of the Ethernet ports is auto-sensing by default and is user
configurable.
The PRP-2 optionally includes a 40-GB hard disk drive (HDD) that is installed on
the PRP-2 board.
Non-Cisco hard disk drives are not supported.
Performance Route Processor Installation and Configuration Guide
Product Overview
17