Setting Asynchronous Serial Ports - Cisco 2500 Series Installation And Configuration Manual

Multiport

Hide thumbs Also See for 2500 Series:

User manual (92 pages)

Deployment manual (23 pages)

Installing manual (12 pages)

Table of Contents

Configuring the Router

Is this interface in use? [no]: yes

Configure IP unnumbered on this interface? [no]: yes

IP address for this interface: 172.16.74.2

Number of bits in subnet field [8]:

Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [yes]:

AppleTalk starting cable range [2]: 4

AppleTalk ending cable range [3]: 4

AppleTalk zone name [myzone]: ZZ Serial

AppleTalk additional zone name:

Configure IPX on this interface? [no]: yes

IPX network number [2]: B002

Step 4 Continue to configure the remaining serial port(s) using similar parameters.

The multiport serial router is now configured properly and is ready to use. Enter the setup command to

modify the parameters after the initial configuration. Enter the configure command to perform more complex

configurations. For additional information, refer to the publication Cisco IOS command reference publication.

Step 5 Check the router settings by entering the show running-config command at the enable prompt:

Router# show running-config

configuration register is 0x2102

Step 6 Store the configuration, or changes to the startup configuration, by entering the copy running-config

startup-config command at the enable prompt:

Router# copy running-config startup-config

Entering this command saves the configuration settings that the setup process created in the router. If you fail

to do this, the configuration is lost the next time the router is loaded.