Cisco PRP-1= Installation And Configuration Manual page 42

Upgrading to the PRP
Upgrade the Mbus-agent-rom by using the command upgrade mbus-agent-rom
Step 18
all. Line cards do not need to be reloaded. If any error messages are displayed (see
following example), repeat this step before contacting Cisco TAC.
MBus agent ROM upgrade failed on slot 7 (rc=5)
MBus agent ROM upgrade failed on slot 8 (rc=6)
Upgrade the fabric downloader by using the command upgrade
Step 19
fabric-downloader all. The line cards do not need to be reloaded. If any error
messages are displayed (see following example), repeat this step before
contacting Cisco TAC.
Fabric-downloader upgrade failed on slot 7 (rc=5)
Fabric-downloader upgrade failed on slot 8 (rc=6)
Make a note of which slot the PRP is installed in the chassis. You can use the show
Step 20
gsr command to view this information. In the following example, the RP is
located in slot 3.
Router# show gsr
Slot 0
Slot 3
Slot 17 type
Slot 18 type
Slot 19 type
Slot 20 type
Slot 24 type
Slot 25 type
Slot 28 type
Use the command upgrade rom-monitor slot rp-slot.
Step 21
Performance Route Processor Installation and Configuration Guide
42
type = 3 Port Gigabit Ethernet
state = IOS RUN Line Card Enabled
type = Route Processor
state = ACTV RP IOS Running
= Clock Scheduler Card(6) OC-192
state = Card Powered
= Switch Fabric Card(6) OC-192
state = Card Powered
= Switch Fabric Card(6) OC-192
state = Card Powered
= Switch Fabric Card(6) OC-192
state = Card Powered
= Alarm Module(6)
state = Card Powered
= Alarm Module(6)
state = Card Powered
= Blower Module(6)
state = Card Powered
ACTIVE
PRIMARY CLOCK
OL-11656-01