Asynchronous/Synchronous Serial Interface—Asynchronous Configuration; Asynchronous/Synchronous Serial Interface—Synchronous Configuration - Cisco 2800 Series Manual

Do you want to map the remote machine's smds address to IP address? [yes]:
Do you want to map the remote machine's smds address to IPX address? [yes]:
Asynchronous/Synchronous Serial Interface—Asynchronous Configuration
The following is a sample configuration for asynchronous configuration for an
asynchronous/synchronous serial interface:
Do you want to configure Serial1/1 interface? [yes]:
Enter mode (async/sync) [sync]: async
Configure IP on this interface? [yes]:
Configure IP unnumbered on this interface? [no]:
Configure LAT on this interface? [no]:
Configure AppleTalk on this interface? [no]:
Configure DECnet on this interface? [no]:
Configure CLNS on this interface? [no]:
Configure IPX on this interface? [no]: yes
IPX network number [8]:
Configure Vines on this interface? [no]:
Configure XNS on this interface? [no]:
Configure Apollo on this interface? [no]:
Asynchronous/Synchronous Serial Interface—Synchronous Configuration
The following is a sample configuration for synchronous configuration for an
asynchronous/synchronous serial interface:
Do you want to configure Serial1/0 interface? [yes]:
Enter mode (async/sync) [sync]:
Some supported encapsulations are
Choose encapsulation type [hdlc]:
The following sections describe the prompts for each encapsulation type. For PPP and High-Level Data
Note
Link Control (HDLC) encapsulation, no further configuration is needed.
No serial cable seen.
Choose mode from (dce/dte) [dte]:
If no cable is plugged in to your router, you must indicate whether the interface is to be used as DTE or
DCE. If a cable is present, the setup command facility determines the DTE/DCE status. If the serial cable
is DCE, you see the following prompt:
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 192.0.0.0
Subnet mask for this interface [255.0.0.0]:
Class A network is 2.0.0.0, 0 subnet bits; mask is /8
Configure LAT on this interface? [no]:
OL-5992-01
IP address for the remote interface: 192.0.0.2
IPX address for the remote interface: 40.1234.5678
IP address for this interface: 192.0.0.0
Subnet mask for this interface [255.0.0.0]:
Class A network is 2.0.0.0, 0 subnet bits; mask is /8
ppp/hdlc/frame-relay/lapb/x25/atm-dxi/smds
Examples of Using the Setup Command Facility to Configure Interface Parameters
Basic Software Configuration Using the Setup Command Facility
11