Configuring Interfaces On The Prp - Cisco PRP-1= Installation And Configuration Manual

Configuring Interfaces on the PRP

Note
Note
Configuring Interfaces on the PRP
Configuring an Ethernet Interface
Ethernet Interface Receptacles, Cables, and Pinouts
Performance Route Processor Installation and Configuration Guide
44
Field diagnostics cannot be run on the PRP-2 unless you are using software
release 12.0(30)S or higher.
The show version command may display incorrect information for the PRP-2
card in software releases prior to 12.0(30)S.
This section includes configuration and connection information for the Ethernet,
console, and auxiliary interfaces on the PRP, and includes the following sections:
Configuring an Ethernet Interface, page 44
•
Configuring the Console Interface, page 51
•
Configuring the Auxiliary Interface, page 53
•
PRP Ethernet interface connection and configuration information is presented in
the following sections:
Ethernet Interface Receptacles, Cables, and Pinouts, page 44
•
Ethernet Interface Cable Connection Procedure, page 48
•
Configuring the Ethernet Interfaces, page 49
•
There are two RJ-45 Ethernet interface receptacles on the PRP and one RJ-45
Gigabit Ethernet interface receptacle on the PRP-2, providing media-dependent
interface (MDI) Ethernet ports. These connections support IEEE 802.3 and
IEEE 802.3u interfaces compliant with 10BASE-T and 100BASE-TX standards.
The transmission speed of the Ethernet ports is auto-sensing by default and is user
configurable.
OL-11656-01