Advertisement
V. Punch hole position adjustment
Make a sample copy in punch mode, then follow the
procedure below if the gap in hole positions is out of
the following specifications.
Standard value: 0 ± 2 mm
Fold the copy in half to check that holes are in cor-
rect alignment with each other.
1. Open the top cover of the Finisher and loosen the
screw that secures the hole punch guide plate.
Slide the green handle to the front or rear to
adjust the position of holes for hole punch.
2. Tighten the screw that secures the hole punch
guide plate.
Note:
Make a copy again and check for correct hole
positions.
If the specifications are not still met, readjust.
3. Close the top cover of the Finisher.
4521IXC012DA
Finisher top cover
4521IXC013DA
VI. Affixing the Label
Affix the labels to the position shown below.
<ADF>
4349U044AB
VII. Registering the Serial Number
Register the serial number of the installed Finisher
to the machine.
The Serial Number is indicated on the back of the
Finisher.
1. Plug the power cord of the machine to the
outlet, and turn on the machine's sub and
main power switches.
2. Touch the "Utility/Counter" key.
3. On the [Utility/Counter] screen, touch
"Details" and press the keys in the following
order [Stop]+[0]+[0]+[Stop]+[0]+[1] to enter
[Service Mode].
4. Touch "System 1."
5. Touch "Serial Number."
6. Touch "Finisher."
7. Enter the Serial Number of the Finisher, and
touch "OK." (Touch "Shift" for switching
between upper case and lower case.)
8. Touch "END" on the screen for the Serial
Number list.
9. Touch "Exit" on the Service Mode to return to
the main screen.
E-5
<On Upper cover/Rr>
4349IXC037DB
Step
Advertisement
