Page 1
FS-518 Finisher INSTALLATION MANUAL Applied Machines: C650/C550 COLOR MFP (Color/B&W): 50 ppm / 65 ppm, 45 ppm / 55 ppm Product Code: A00H/A00J Note: Name Shape Q’ty Lifting the machine in an awkward position or 8. Screw A transporting it in a poorly balanced position could (4 ×...
II. Confirmation before installation III.Installation procedures 1. When transporting the finisher, be sure to move it 1. Turn off the machine and unplug the power cord in the direction illustrated below so as not to from the power outlet. deform the casters on the paper exit tray side. 2.
Page 3
5. Remove the protective sheet of the horizontal 8. Install the mounting bracket A (left) and mounting transport unit. bracket C (right), shipped with the finisher, to the upper portion on the left side surface of the machine. • Mounting bracket A: two screw A’s furnished with the finisher.
Page 4
9. Install the mounting bracket B (left) and mounting 11. Remove the locking tapes from each guide bracket C (right) shipped with the finisher to the plates. lower portion on the left side surface of the 12. Remove the stacker locking materials. machine (four screw B’s furnished with the fin- isher).
Page 5
14. Connect the three finisher connectors to the 16. Open the front door of the finisher and secure connectors located on the rear left side of the the finisher to the machine (two mounting machine. screws furnished with the finisher). A07UIXC013DA A07UIXC016DB 15.
Page 6
(2) Remove the rear left cover of the finisher 18. Insert upper exit tray into the sub tray paper exit (three screws). slot on the finisher. Note: When installing upper exit tray, push the tray all the way in until you hear a click. A07UIXC018DB (3) Remove the rear lower cover of the finisher (seven screws).
Page 7
21. Reinstall the user's guide holder, which has been removed in step 2, to the upper or lower position shown. Mounting the holder to the upper position A07UIXC024DA Mounting the holder to the lower position A07UIXC025DA...