Advertisement
7. Install the fixing brackets A and B in two loca-
tions. (SEMS ll screw M4x12: 2pcs each.)
Note:
Ensure that fixing brackets B face inward.
8. Install the positioning pin.
(Bind screw M4x10: 2pcs.)
Note:
Install the positioning pin so that its flat spring is on
the bottom side.
Positioning Pin
Fixing brackets B
9. Connect the Finisher connector to the Relay Unit,
then fasten the connector cord using the nylon
clamp (Relay Unit accessory part) as shown
below to take up the slack in the cord. (TP screw
M3x6: 1 pc.)
Nylon clamp
(Relay Unit accessory parts)
10. Fit the rail into the mounting guide on the Fin-
isher tray side and insert the rail until a click is
heard.
Note:
At this time, do not press the Finisher up against
the main body, yet.
Bind
screws
M4x10
Fixing brackets A
SEMS II screws
M4x12
4521IXC018DB
Relay Unit
TP screw M3x6
(Relay Unit accessory parts)
4521IXC019DB
4521IXC020DA
IV. Adjusting the position of the Finisher
1. Slowly move the Finisher toward the main body
and check the followings.
• Alignment between the positioning pin and the
hole in the Finisher. (height) (in the rear)
• Alignment between fixing bracket A and the fix-
ing bracket on the Finisher. (height) (at the front)
• Alignment between the surface A of the Relay
Unit and surface B of the Finisher. (height)
(Open the Finisher top cover to check it.)
• The gap between the Finisher and the main
body should be uniform. (See step 5 on page 4)
Note:
The following steps 2 to 7 should be performed
only if any part is found in inappropriate position.
2. Remove the Lower front cover of the Finisher. (2
screws)
E-3
Surface B of the Finisher
Surface A of the Relay Unit
At the front
In the rear
4521IXC021DA
Lower front cover
4521IXC007DA
Advertisement
