Advertisement
3-5. TUNER STEP mode (E3 only)
3-5.1. Actions
This is a special mode for enabling reception STEP of the ANALOG TUNER to be changed.
3-5.2. Starting up
While holding down buttons "ZONE3 SOURCE" and "STATUS" simultaneously, press the power button
to turn on the power.
Select the "5. TUNER FRQ SET" using the "CURSOR f / d " button, then press the "ENTER" button to
confirm.
3-5.3. Displays
Start up this unit in TUNER STEP mode, select the desired option using the "CURSOR 0 / 1 " button,
then enter using the "ENTER" button.
The following information is displayed in the following order.
(1) AM9 kHz / FM50 kHz is selected
L1
*TUNER FRQ Set
L2
<
AM9/FM50
>
"CURSOR 0 "
"CURSOR 1 "
(2) AM10 kHz / FM200 kHz is selected
L2
< AM10/FM200 >
"ENTER"
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
3-6. Remote ID Setup Mode
3-6.1. Actions
This function allows only the desired AV receiver to be operated if multiple DENON AV receivers are
used in the same room.
3-6.2. Starting up
While holding down buttons "ZONE3 SOURCE" and "STATUS" simultaneously, press the power button
to turn on the power.
Select the "6. REMOTE ID" using the "CURSOR f / d " button, then press the "ENTER" button to
confirm.
3-6.3. Operations
(1) When Remote ID Setup mode is activated, the following message is displayed.
L1
L2
REMOTE ID ?
(2) Press the desired "QUICK SELECT 1 - 4" button.
Button
QUICK SELECT 1
L2
QUICK SELECT 2
L2
QUICK SELECT 3
L2
QUICK SELECT 4
L2
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
b Only "QUICK SELECT 1 - 4" and the POWER button on the unit can be used in Remote ID Setup
Mode.
3-6.4. Setting the Remote control unit
(1) Press and hold the "DEVICE MENU" button for at least 3 seconds until the "DEV.", "TU" and "AVR"
indicators flash.
(2) Press "MAIN" button.
The "DEV.", "TU" and "AVR" indicators flash twice.
(3) Press the "1", "2", "3" or "4" button.
The "DEV.", "TU" and "AVR" indicators flash twice.
NOTE :
If the ID of the unit and remote control do not match, "AVAMP z " appears on the display of the unit
when the remote control is used
( z : own remote control ID).
152
Display
REMOTE ID 1
REMOTE ID 2
REMOTE ID 3
REMOTE ID 4
Advertisement
