Advertisement
3-2. Error Code H1-02 failure detection procedure
Checking device.
[U2401 :
MN864788]
Check the power supply voltage. (HDMI SW1)
Check item(3-2.1.).
Check the power supply voltage. :
Does the power supply voltage of the HDMI SW1 [U2401] indicate the correct voltage (1.1V, 3.3V)?
The test points are as follows.
HDMI SW1
112 pin
U2401
1.1V
3.3V
38 pin
YES
Check item(3-2.2.).
Check the power components [U3604] and the pattern on the sub-
strate.
If there is no problem, remove the HDMI SW1 [U2401] from the
substrate and measure the voltage at the test point of
(3-2.1.).
Is the voltage correct (1.1V or 3.3V)?
Replace with a new device.
Recheck from
If it does not work, replace the PCB.
NO
Check the power supply voltage. :
check item
YES
NO
The power supply circuit is
faulty.
Replace the PCB.
check item (3.1.)
Checking the reset waveform. (HDMI SW1)
Check item(3-2.3.).
Checking the reset waveform :
Check the waveform.
Is the TP waveform of the TP near the HDMI SW1 [U2401] correct
(like the one shown in the diagram) when the power is turned
on?
HDMI SW1
RESET
U2401
YES
check item (3.1.)
again after replacing [R2460/R2461] with a new
resistor.
If there is still a problem, the HDMI SW1 [U2401] is faulty.
Replace with a new device.
Recheck from
check item (3.1.)
If it does not work, replace the PCB.
104
Examples of confirmation waveform
Voltage scale : 1.0V/div
Time scale : 20ms/div
NO
Check the reset circuit between
CPU [U6201] and HDMI SW1
[U2401].
If there is no problem, the HDMI
SW1 [U2401] is faulty.
Replace with a new device.
Advertisement
