Names And Functions Of Components; Front View - NEC Express5800 Series User Manual

2-4 General Description

NAMES AND FUNCTIONS OF COMPONENTS

This section describes the names and features of the components in the device.

Front View

2
3
4
5
6
1 LTO drive
2 POWER lamp
The lamp goes on green when the Tape Blade is
powered on.
The lamp goes on amber when the Tape Blade is
powered off but the power is supplied from the
power supply unit.
3 STATUS lamp (green/amber/red)
The lamp indicates the status of the Tape Blade.
See "Lamp Indications" described later for the
indications and meanings of the lamp.
4 LAN1 Link/Access lamp (green)
The lamp lights when LAN port 1 is connected to
the network.
The lamp flashes when data is being transmitted.
7
8
1
9
7
5 LAN2 Link/Access lamp (green)
The lamp lights when LAN port 2 is connected to
the network.
The lamp flashes when data is being transmitted.
6 ID lamp (blue)
The lamp is intended to identify the Tape Blade
in the system. The lamp is lit by a software
command.
7 Eject lever
Pull the lever to remove the Tape Blade from the
Blade Enclosure.
8 Slide tag
The label that indicates the N-type number and
serial number is attached here.
9 Cartridge door
8
7