NEC Express5800 Series User Manual page 100

9-8
Upgrading Your Tape Blade
IMPORTANT:
with any electronic components on the Tape Blade.
6.
Make sure the location of mezzanine card slot you are going to install.
7.
From top of the Tape Blade, position the connector of the mezzanine card so that it aligns
the connector of the mezzanine card slot, and insert the mezzanine card straight into the
slot.
Type I
IMPORTANT:
Do not make your body contact with the terminals on the board.
Some malfunction may occur if the board is installed with dirt
and/or oil adhering to the terminals.
Insert the mezzanine card straight into the connector. The terminal
or connector may be damaged if it is inclined.
If the board cannot be installed securely, remove the board once and
then install it again. Adding excess force to the board may cause the
board to be damaged.
Handle the cover carefully so as not to make it contact
Type II