Audio/Video Dubbing - Hitachi VM-SPIA Instruction Manual

AUDIO/VIDEO DUBBING

AUDIO/VIDEO DUBBING
Audio/video dubbing lets you record new audio and video from another VCR on a
previously recorded tape in the camera/recorder.
Audio/video dubbing hookup Illustration
NOTES:
• If no video and audio plugs are connected, new audio and video from the
camera/recorder's built-in microphone and camera is dubbed onto the tape.
• If the AV dub/pause mode continues for more than 5 minutes, the camera/recorder will
automatically enter the stop mode to protect the tape from damage.
1. Insert a recorded tape.
Be sure that the red record-protect tab is not closed.
2. Turn the operate control to select "VCR".
3. Aim the remote controller at the receiver of the camera/recorder.
4. Press "PLAY" button and then "REW" or "F.FWD" button to search to the
approximate area on the tape where you want to begin your dub.
5. Press "PLAY" button again to search for the exact position that you want to stop
dubbing, then press "PAUSE" button.
6. Press "DISPLAY" button so that the linear time counter with memory appears and
then press "RESET" button to set the counter reading to "0:00:00M".
7. Press "REW" button to rewind the tape to the approximate position that you want to
start dubbing.
8. Press "PLAY" button, and when the exact position that you start to dub is reached,
press "PAUSE" button.
9. Press and hold the "A/V DUB" button, and then press the "PLAY" button. "A/V DUB"
appears in the viewfinder, and at the same time the picture to be dubbed appears.
10. Press "PAUSE" button again.
A/V dubbing will start and will stop when the counter reads "0:00:00M".