Hitachi VM-SPIA Instruction Manual page 37

IDENTIFICATION AND OPERATION OF CONTROLS
NOTE: You can also visually scan backward when the camera/recorder is in record/pause
(stand-by) mode by pressing and holding this button.
34. "PLAY" Button
Used for playback of tape.
NOTE: When the camera/recorder is in record/pause (stand-by) mode, pressing and
holding this button will play the tape at normal speed.
35. "F.FWD" Button
Press this button during stop or rewind mode, and fast-forwarding starts.
Press the button during playback of tape, and the tape is played back in the forward
direction approximately 9 times faster than the normal speed to confirm the recorded
content.
Press "PLAY" button to return to normal playback mode or press "STOP" button to stop
tape movement.
NOTE: You can also visually scan forward when the camera/recorder is in record/pause
(stand-by) mode by pressing and holding this button.
36. "RESET" Button
When the linear time counter is displayed in the viewfinder, pressing this button resets
the counter to "0:00:00".
37. "MENU" Button
Use this button to select the camera/recorder's function.
To house the remote control in the camera/recorder
House the remote control while it is caught by the two tabs as shown in the figure.
NOTE: The remote control is not water resistant.
To remove the remote control
Press the button and hold it, then remove the remote control.