Hitachi VM-SPIA Instruction Manual page 32

MAKING A SAMPLE CAMERA RECORDING
NOTES:
• The "TAPE END" indication in the viewfinder starts flashing when there is less than three
minutes recording time left on the cassette.
• If the record/pause mode continues for more than 5 minutes, the camera/recorder's power
is automatically turned off. To turn on again, turn the operate control to select "ZOOMx16"
again. The camera/recorder enters record/pause (stand-by) mode.
9. After recording, set the operate control to "VCR", and the camera/recorder will now
be in the stop mode.
10.Open the case. Be careful that no water or sand enters the camera/recorder. Refer
to "WATER-RESISTANT" on page 8.
11. Press "REW" button. The tape will be rewound to the beginning.
12. Press "PLAY" button. The picture you just recorded will be seen through the
viewfinder.
NOTE: If you connect the camera/recorder to your TV, you can see the picture played back
on your TV. Refer to "VIEWING THE PICTURE PLAYED BACK ON YOUR TV" on page
38.
13. After playing, press "STOP" button.
14. Slide "EJECT" switch to remove cassette.
15. Always remove the power source from the camera/recorder after use.