Water-Resistant - Hitachi VM-SPIA Instruction Manual

WATER-RESISTANT

WATER-RESISTANT
WATER-RESISTANT STRUCTURE
When the buckle is locked, the VM-SP1A is sealed within the case via the water-
resistant seal to keep it water-resistant.
Note: The VM-SP1A cannot be used under water because it is not water-proof.
How to handle the water-resistant seal
• Inspect the water-resistant seal regularly to check that the seal is not damaged or cut
which would allow water to enter the case.
• Check that no foreign matter adheres to the water-resistant seal before closing the
case. If the VM-SP1A is used while sand or other particulates adheres to the seal, it
could cause water to enter.
• The water-resistant seal should be replaced at least once a year. Use Hitachi part #
VM-KIT270.
The VM-SP1A cannot be used in the following places
• Under water
• In a place with high temperature and high humidity such as in a sauna, steam room,
etc.
Note: The camera/recorder inside the case is not meant to be water-resistant. Do not let
water get inside the outer housing.
HOW TO OPEN AND CLOSE THE CASE