Setting The Rotational Speed; Mounting/Adjusting The Additional Handle; Attaching/Removing Sanding Sheet; Switching On And Off - Parkside PAEXS 20-Li B2 Translation Of The Original Instructions

GB IE
If necessary, you can connect the
suction tube of a vacuum cleaner
directly to the device without an
adapter.

Setting the rotational speed

You can set the rotational speed variable
via the rotational speed selection wheel
(2).
Mounting/adjusting the
additional handle
Mounting the additional handle
1. If necessary, loosen the wing nut (4)
and screw (4a) from the additional
handle (3).
2. Slide the additional handle (3) over the
handle unit (13) on the tool.
3. Fix the additional handle (3) with the
screw (4a) and wing nut (4).
Adjusting the additional handle
1. Loosen the wing nut (4).
2. Adjust the additional handle (3) to the
desired position.
3. Tighten the wing nut (4) again.
Attaching/removing
sanding sheet
Clean the sanding disc before you
attach a sanding sheet.
Always remove the battery before
working on the tool.
Use only appropriate sanding sheet
sizes. Sanding sheets, which ex-
tend beyond the sanding disc, can
cause injuries and can cause the
sanding sheets to block or tear.
12
The sanding disc (5) is fitted with Velcro for
rapid attachment of the sanding sheet (11).
Removing sanding sheet:
Remove the sanding sheet (11) from the
sanding disc (5).
Attaching sanding sheet:
Press the sanding sheet (11) evenly onto
the sanding disc (5).
Ensure that the sanding sheet lies flush and
the holes are placed directly above the
extraction openings of the sanding disc
(5). Use the sanding sheet fixer (9) for this
purpose.
The sanding disc will continue
to run after switching off.
Wait until the sanding disc
has come to a complete stop.

Switching on and off

Switch the machine on before you
approach the material to be sand-
ed.
Switching on the device
1. Slide the On/Off switch to position
"1".
Switching off the device
2. Slide the On/Off switch to position
"0".
Removing/inserting the
battery
1. To remove the battery (7) from the de-
vice, press the release button (7a) on
the battery and pull the battery (7) out.
2. To insert the battery (7), push the bat-
tery (7) along the guide rail into the
device. You will hear it click into place.