Dust box
Connecting
♦
Slide the dust box
as the stop.
Removal
♦
Pull the dust box
NOTE
►
To achieve optimum dust extraction, the dust
box
should be emptied regularly.
♦
To do this, remove the dust box
appliance as described above. Open the dust
box by pulling on the tab
the lid. Clean both parts thoroughly by tapping.
Reducer
Connecting
♦
Push the reducer for external extraction appli-
ances
into the adapter fitting
♦
Push the hose from a suitable dust extraction
appliance (e.g. a workshop vacuum cleaner)
onto the reducer for external extraction appli-
ances
.
Removal
♦
Pull the hose of the vacuum cleaner off the
reducer for external extraction appliances
♦
Remove the reducer
PAEXS 20-Li A1
onto the appliance as far
off the appliance.
from the
and then removing
.
.
Use
NOTE
►
Always switch on the appliance before contact
with the material and then apply the tool to the
workpiece.
Adjusting the additional handle
You can adjust the additional handle
different positions.
♦
To reposition the additional handle
the screw
♦
Move the additional handle
position.
♦
Retighten the screw
Switching on and off
Switching the appliance on
♦
Move the ON/OFF switch
Switching the appliance off
♦
Move the ON/OFF switch
Setting the rotational speed
♦
Adjust the speed setting wheel
between 1 and 6.
Working procedures
.
■
Switch the appliance on before applying it to
the workpiece.
■
Apply minimal pressure when working.
■
Work at a constant speed.
■
Change the sanding sheets regularly.
■
Never use the same sanding sheet for sanding
different materials (e.g. wood followed by
metal). Optimum sanding results can only be
achieved by using clean sanding sheets.
.
to the required
.
to the "I" position.
to the "0" position.
to a position
GB │ IE
to several
undo
│
9
■