Checking The Charge Level Of The Rechargeable Battery; Removing/Changing The Sanding Disc; Practical Tips - Parkside PAEXS 20-Li B2 Translation Of The Original Instructions

Checking the charge level of
the rechargeable battery
The battery charge level indicator signal-
ises the state of charge of the battery (7).
Press the button for the charge level indica-
tor (7b) on the battery.
The charge level of the battery is indicated
by illumination of the corresponding LED
light.
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
Charge the battery (7) when only
the red LED on the level indicator is
illuminated.
Removing/changing the
sanding disc
1. If necessary, remove the sandpaper
sheet (5).
2. Loosen the four Phillips screws (14).
3. Remove the sanding disc (5) from the
motor unit.
4. Install the sanding disc (5) again in
reverse order.
Make sure that the extraction openings
on the sanding disc line up with the
threaded holes in the motor unit.
Replacement sanding discs are
available from our online shop (see
"Spare parts/Accessories").

Practical tips

When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Do not use the device without a
dust collection box or external dust
extraction. Use of a dust extraction
can reduce hazards caused by
dust.
When using sanding sheets without
ventilation holes, dust extraction
is not possible. Make sure that the
workplace is well ventilated.
Remove the battery before carrying
out any adjustments, maintenance
or repair work.
• Move the appliance against the work-
piece once it is switched on.
• After machining, lift the sanding disc
up before turning off the device.
• Clean the sanding disc before attach-
ing a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work with low and even pressure and
even forward pressure. This protects the
appliance and the sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal and
then wood).
• Empty the dust collection box or the
GB IE
13