If there is a retaining clip, check to make sure that it has not been damaged or bent. (See
Step 3
Note
Figure 54
If the retaining clip is damaged, do not use it. This can damage the SODIMM socket.
Caution
Locate the route memory socket on the line card.
Step 4
Remove the new SODIMM from its protective antistatic bag.
Step 5
Grasp the edges of the SODIMM only. Do not touch the integrated circuit devices on the SODIMM; the
Caution
metal traces, or fingers, along the edge of the SODIMM; or the pins in the SODIMM socket.
Step 6
Line up the SODIMM key with the key in the board socket. (See
OL-7861-01
Some line cards do not require a retaining clip.
SODIMM Socket Retaining Clip
Figure
Cisco XR 12000 Series Router Ethernet Line Card Installation
Line Card Memory
Figure
54.)
55.)
75