Cisco XR 12000 Series Installation Manual page 30

Removing and Installing SFP Modules
Figure 20
Removing a Mylar Tab SFP Module
To remove this type of SFP module, follow these steps:
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 1
Disconnect and remove all interface cables from the ports; note the current connections of the cables to
Step 2
the ports on the line card.
Pull the tab gently in a slightly downward direction until it disengages from the port, then pull the SFP
Step 3
module out. (See
Figure 21
Step 4 Place the removed SFP module on an antistatic mat, or immediately place it in a static shielding bag if
you plan to return it to the factory.
Cisco XR 12000 Series Router Ethernet Line Card Installation
30
Mylar Tab SFP Module
Figure 21.)
Removing a Mylar Tab SFP Module
2
3
4 O C
4 8 / S
R P - S
F P
OL-7861-01