Screw-Mounting The Adapter; Using The Stand Adapter - VeriFone PINpad 1000SE Installation Manual

S
ETUP
Use Stand Adapter
Screw-Mounting
the Adapter
Using the Stand
Adapter
14
PIN 1000SE I
PAD NSTALLATION
The stand adapter may also be screwed directly to a wall or countertop.
•
Use screw anchors when fastening the adapter to a cement or brick wall.
•
When fastening the plate to drywall, the screws must go into the studs behind
the wall. Screw anchors alone will not safely hold the adapter to drywall.
To screw-mount the stand adaptor, use American National Standard #8 or Metric
M3 screws, with head diameter between 4.5 and 6.0mm, and head thickness less
than 2.5mm. Use the stand adaptor to mark the hole placement on the desired
location, and then insert screws, adjust the screw depth until the unit is firmly
mounted.
Figure 6 shows how to insert a PINpad 1000
end of the PINpad 1000
the screen end of the PINpad 1000
until you hear and feel the release lever click.
Figure 6 Inserting the PINpad 1000
Removal is simply the reverse: press the release lever at the top of the stand
adapter and pull the PINpad 1000
G
UIDE
SE
unit into the bottom of the stand adapter, then press
SE
unit firmly into the top of the stand adapter
SE
device into the Stand Adapter
SE
unit up and out of the stand adapter.
SE
unit into a stand adapter. Slide the