Connect Unit To A Pc/At (Optional) - VeriFone PINpad 1000SE Installation Manual

S
ETUP

Connect Unit to a PC/AT (optional)

Connect Unit
to a PC/AT
(optional)
12
PIN 1000SE I
PAD NSTALLATION
Figure 3 illustrates how to connect the PINpad 1000
series terminal. For other terminal or controller connections, refer to the reference
manual for that controller.
Figure 3 PINpad 1000
1
Disconnect power from the terminal.
2
Connect the modular plug on the cable to the modular jack on the rear of the
PINpad 1000 device.
SE
3
Connect the other end of the cable to the PlNpad port on the rear of the
terminal.
4
Reconnect power to the terminal.
If the PINpad 1000 device is going to be connected to an IBM PC/AT or
SE
compatible for general use, or the PC/AT will be running MKIXOR software for key
insertion, VeriFone sells special cable products to provide power to run the
PINpad 1000 (refer to
SE
how to connect the PINpad 1000
Figure 4 PINpad 1000
G
UIDE
OMNI 37XX
and Terminal Cable Connections
SE
Accessories and Documentation).
to an IBM AT or compatible computers.
SE
and IBM AT Cable Connections
SE
device to an Omni 37xx
SE
PINPAD 1000SE
Figure 4 illustrates