Installation Location - Dimplex DHW 250P Installation And Operating Instructions Manual

English

7. Installation location

7.1. Selecting the installation location
ATTENTION!
Take the following into account during in-
stallation: The device must not be installed
close to a constant flame or other ignition
source. The device must be installed so that
mechanical damage is avoided.
It is forbidden to install the device as follows:
outdoors,

in rooms with exposure to frost or with a tempera-

ture below 7 °C, even if the device is in operation,
in extremely humid rooms with high steam levels

(e.g. bathrooms),
in rooms where there is a risk of explosion due to

the presence of gases, vapours or dust.
Installation close to bedrooms should be avoided

to guarantee comfortable noise levels.
It is forbidden to
operate the device with intake air containing sol-

vents or potentially explosive substances,
use intake air containing grease, dust or aerosols,

connect extraction hoods to the ventilation sys-

tem,
use air containing boiler combustion products.

EN-8
7.2. Arrangement and fixing
To guarantee that the domestic hot water heat pump
works normally and to make maintenance work easier,
a minimum distance around the device and a mini-
mum ceiling height for removing the device cover
must be observed.
The floor must have an adequate load bearing capac-
ity (weight of the domestic hot water heat pump, filled
with 250 l water = 335 kg).
NOTE
The domestic hot water heat pump must be installed
vertically. Otherwise, condensate may overflow, caus-
ing water to accumulate on the floor.
Use the fixing point to fix the cylinder on the floor and
fix the device via the metal tongue with a Ø M8 screw
that can be dowelled on to the floor (see 1).
FD 0207
Installation location
1
www.dimplex.de