IBM eServer pSeries 630-6C4 Quick Setup Instructions Manual page 8

10
Tighten the rail retaining screws
10.1
Take along your screwdriver or nut driver to the rear of the rack.
10.2
Use your screwdriver or nut driver to tighten the four rear rail retaining screws.
10.3
With your screwdriver or nut driver, return to the
front of the rack.
10.4 Pull the system drawer approximately half way out
of the rack.
10.5
Use your screwdriver or nut driver to tighten the four
front rail retaining screws.
10.6 Slowly slide the system back and forth, watching
for any signs of binding. If binding occurs, loosen
the eight screws and slide the system back and
forth on the rails several more times. With the
system completely retracted in the rack, repeat
substeps 10.1 through 10.5.
F R
O
N T
R I
G H
T
S I
D E
Note: To unlock extended rails, push in the
rail safety release latch, located on each rail,
then push the system in toward the rack.