IBM eServer pSeries 630-6C4 Quick Setup Instructions Manual page 6

6
Install the rails (continued)
6.6 Go to the rear of the rack. Attach
two 7 mm screws to the left rail.
6.7 Attach a 7 mm screw through
the bottom-right-rail screw hole.
(As viewed from the back of the rack.)
6.8
Locate the cable-management arm bracket.
Position the bracket's bottom hole over the
rail's top alignment pin. Attach a 7 mm retaining
screw through the bottom slot of the bracket. See the illustration.
7
Remove the system from the box
Use this size 7 mm screw
to complete this step.
CAUTION: The unit weighs between 32 kg (70.5 pounds)
and 55 kg (121.2 pounds). Three persons are required to
safely move it. Using less than three persons to move it
can result in injury.
Remove the box marked 2 from the
7.1
shipping box and put it in a safe place.
Remove all of the foam padding from
7.2
around the system.
Lift the shipping box up and away from the system.
7.3
Top
alignment
pin
Remove the protective plastic
7.4
covering from around the system.