Table of Contents
Advertisement
6
FORK, TRIPLE CLAMP
Bleedin
Info
Before working with the vacuum pump, carefully read the vacuum pump operating manual.
-
Tighten the cartridge.
I
Guideline
Cartridge on the outer tube
I
Ring wrench (T14017)
Mount adjuster � of the compression damping. Mount and tighten the screw.
Guideline
Screw, compression adjuster
Alternative 1
-
Turn adjusting screw of compression damping
rebound damping
-
Turn back counterclockwise by the number of clicks corresponding to the fork
type.
Guideline
Rebound damping
Comfort
201366-10
Standard
Sport
Compression damping
Comfort
Standard
Sport
Alternative 2
Warning
Danger of accident
seriously alter the handling characteristic.
Extreme modifications to the suspension setting may cause a serious
deterioration in the handling characteristic and overload components.
-
-
-
Set the adjusting screws to the position determined before removal.
-
Mount protection cap G).
the cartrid e
-
Clamp the cartridge as shown in the figure.
I
Guideline
Use soft jaws.
Info
Clamp the cartridge only lightly.
The filling port must be located at the highest point.
During the filling procedure, the cartridge must be lower than the oil tank
of the vacuum pump.
The piston rod moves in and out during filling; do not immobilize it by
holding it with your hand.
-
Remove the screw of the filling port.
-
Mount special tool
I
Filling adapter (T14030)
I
M51x1.5
(�
p. 238)
M4x0.5
4B
clockwise all the way.
Modifications to the suspension setting may
Only make adjustments within the recommended range.
Ride slowly to start with after making adjustments to get the feel of
the new handling characteristic.
O
on the cartridge.
(�
p. 239)
I
50 Nm (36.9 lbf ft)
1.5 Nm
(1 .11 lbf ft)
«8
and adjusting screw of
14 clicks
12 clicks
10 clicks
14 clicks
12 clicks
10 clicks
34
I
Advertisement
Table of Contents
