Brake System; Checking The Front Brake Linings; Changing The Front Brake Linings - Husqvarna FS 450 2015 Repair Manual

Table of Contents

Advertisement

16

BRAKE SYSTEM

Checkin the front brake linings
Warning
Danger of accidents
-
Ensure that worn-out brake linings are replaced immediately.

Changing the front brake linings

Warning
Danger of accidents
-
Ensure that service work and repairs are performed professionally.
A
Warning
Skin irritation
Brake fluid causes skin irritation.
-
Keep brake fluid out of the reach of children.
-
Wear suitable protective clothing and safety glasses.
-
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
-
Consult a doctor immediately if brake fluid has been swallowed.
-
Rinse the affected area with plenty of water in the event of contact with the skin.
-
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact with the eyes.
-
If brake fluid spills on to your clothing, change the clothing.
A
Warning
Danger of accidents
-
Make sure that brake fluid for the front and rear brake is changed in accordance with the service schedule.
Warning
Environmental hazard
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
Worn-out brake linings reduce the braking effect.
-
Check the brake linings for minimum thickness 6) .
I
Minimum thickness 6)
If the minimum thickness is less than specified:
-
Change the front brake linings.
-
Check the brake linings for damage and cracking.
If damage or cracking is visible:
-
Change the front brake linings.
Incorrect maintenance will cause the brake system to fail.
Old brake fluid reduces the braking effect.
Hazardous substances cause environmental damage.
-
Remove screws
-
Press back the brake linings with a light lateral tilting of the brake caliper on the
brake disc. Pull the brake caliper carefully back from the brake disc and hang it to
one side.
Info
Do not pull the hand brake lever when the brake caliper is removed.
I
<'= 1 mm (<'= 0.04 in)
(il!,!l
p. 111)
(!el
p. 111)
O
8.
with washers
111

Advertisement

Table of Contents
loading

Table of Contents