Installing The Front-Panel Drive Inserts - Dell PowerEdge 1800 Installation And Troubleshooting Manual

Figure 7-2. Removing the Chassis Drive Insert

Installing the Front-Panel Drive Inserts

CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the
online or telephone service and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTICE:
You must install both inserts in an empty 5.25-inch drive bay to maintain Federal
Communications Commission (FCC) certification of the system. The inserts also help keep dust and dirt
out of the system.
1
Install the chassis drive insert by sliding the insert into the chassis until the tabs on the side of
the insert snap into place. See Figure 7-2.
2
Install the bezel drive insert by sliding the insert into the bezel until the tabs on the side of
the insert snap into place.
3
If your system is configured as a tower, stand the system upright.
4
Close the system. See "Closing the System" in "Troubleshooting Your System."
tabs (2)
chassis drive insert
Installing Drives
97