2.
Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WLAN module (3).
3.
If the WLAN module antenna is not connected to the terminal on the WLAN module, install a protective
sleeve on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
Speakers
To remove the speakers, use this procedure and illustration.
Table 5-5
Speakers description and part number
Description
Speakers (include cables, left and right speakers, and 4 rubber isolators)
Spare part number
N15439-001
Speakers
51