Preliminary Steps - Fujitsu PRIMERGY RX2520 M4 Upgrade And Maintenance Manual

System board and components

15.7.1.1 Preliminary steps

"Locating the defective server" on page 45
Ê
"Note on network settings recovery" on page 381
Ê
"Suspending BitLocker functionality" on page 67
Ê
"Shutting down the server" on page 48
Ê
"Disconnecting the power cord" on page 49
Ê
Ê Disconnect all external cables.
Ê Remove all PSUs, see section
"Getting access to the component" on page 50
Ê
"Removing the air duct" on page 61
Ê
"Removing the fan holder" on page 63
Ê
Ê Remove all expansion cards, see section
page 213.
I
Before removing the expansion cards, take a note on the installation
slot number for each card. Make sure that you install the card again
in the slot it was located before the replacement.
"Removing the crossbar" on page 65
Ê
Ê Remove all memory modules, see section
page 244.
I
Before removing the memory modules, take a note on the installation
slot number for each memory module. Make sure that you install the
memory modules again in the slot they were located before the
replacement.
Ê If applicable, remove the iRMC microSD card, see section
iRMC microSD card" on page
Ê If applicable, remove all M.2 SSDs, see section
page 369.
382
"Removing a PSU" on page
362.
Upgrade and Maintenance Manual
"Removing an expansion card" on
"Removing a memory module" on
"Removing the M.2 SSD" on
104.
"Removing the
RX2520 M4