Installing The Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX2520 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.3.3

Installing the expansion card

Ê If applicable, install the slot bracket, see section
page 198.
Ê Install the expansion card, see section
page 208.
9.4.3.4

Concluding steps

"Reassembling" on page 55
Ê
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the power cord" on page 59
Ê
"Switching on the server" on page 60
Ê
"Enabling replaced components in the BIOS" on page 84
Ê
Ê Inform the customer about changed WWN and MAC addresses, see section
"Looking up changed MAC/WWN addresses" on page
"Updating expansion card firmware (iRMC S5)" on page 76
Ê
"Resuming BitLocker functionality" on page 89
Ê
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer.
For more information, see section
recovery" on page
Ê If applicable, restore LAN teaming configurations, see section
replacing a system board" on page
216
215.
95.
Upgrade and Maintenance Manual
"Installing a slot bracket" on
"Installing an expansion card" on
91.
"Note on network settings
"After
RX2520 M4