Concluding Steps - Fujitsu PRIMERGY RX2520 M4 Upgrade And Maintenance Manual

Ê Connect the SAS cables to the SAS expander board (see orange arrows):
– (1) from backplane 1 connector "X9" to connector "X10"
– (2) from backplane 1 connector "X10" to connector X11
– (3) from backplane 2 connector "X9" to connector X12
– (4) from backplane 2 connector "X10" to connector X13
– (5) if applicable, from backplane 3 connector "X9" to connector "X14"
– (6) if applicable, from backplane 3 connector "X10" to connector "X15"
– (7) from SAS controller connector "MCL1" to connector "X1"
– (8) from SAS controller connector "MCL2" to connector "X2"
Ê Connect the power cable to connector "X3" on the SAS expander board (9).

7.3.11.4 Concluding steps

"Installing the fan holder" on page 64
Ê
"Installing the air duct" on page 62
Ê
"Reassembling" on page 55
Ê
"Connecting the power cord" on page 59
Ê
"Switching on the server" on page 60
Ê
"Resuming BitLocker functionality" on page 89
Ê
RX2520 M4
Hard disk drive (HDD) and solid state drive (SSD)
Upgrade and Maintenance Manual 151