Cisco CISCO1750 Installation Manual page 74

Installing a Mini-Flash Module
Figure 5
Notched edge
Follow these steps to install a mini-Flash memory module on the motherboard:
You need to remove the motherboard from the chassis to remove the
Note
mini-Flash memory module.
Step 1 Locate the module slot on the motherboard, shown in Figure 2.
Hold the module with the notched edge away from you.
Step 2
Insert the module into the module slot at a 45-degree angle, as shown in Figure 5.
Step 3
Press down firmly on the module until you hear a clicking sound and the module
Step 4
is firmly seated in the slot.
Turn the motherboard back to its original position (right-side up) and place it in
Step 5
the chassis as before.
Cisco 1750 Router Hardware Installation Guide
viii
Installing a Mini-Flash Module
Mini-Flash module slot
45 degrees
78-6169-02