Optional Installation Steps
Wall-Mounting
The router can be wall-mounted using two number 6, 3/4-inch screws and the
molded mounting brackets on the bottom of the hub. You must provide the screws.
We recommend using pan-head or round-head screws.
Figure 7
Mounting
Mounting
Follow these steps to mount the router on a wall or other surface:
Install the two screws 3.75 inches (9.52 centimeters) horizontally apart on a wall
Step 1
or other vertical surface.
The screws should protrude 0.25 inches (0.64 centimeters) from the surface of the
wall.
Hang the router on the screws with either the left side or right side mounting
Step 2
brackets so that
Cisco 1750 Router Hardware Installation Guide
xiv
Wall-Mount Brackets—Bottom of Router
bracket
3.75"
Bottom
(9.52 cm)
of router
bracket
The LEDs are visible to the user. The LEDs indicate the router operating
•
status, so the LEDs should be easily visible.
The power supply does not hang from its cable. If the power supply is not
•
supported, it might disconnect from the cable that connects it to the router.
Front panel of router
Mounting
bracket
Mounting
bracket
78-6169-02