Cisco CISCO1750 Installation Manual page 19

Table 2 Rear-Panel Connectors (continued)
Connector/Slot
WIC/VIC slot
WIC/VIC slot
VIC slot
Power socket
Protective earth
Use the rear-panel LEDs during router installation to confirm that you have
correctly connected all cables to the router.
Table 3
LED Label
FDX
100
LINK
SLOT 0 OK
SLOT 1 OK
78-6169-02
Label/Color Description
SLOT 0 Supports either a Cisco WIC or VIC. For detailed
information, refer to the Cisco WAN Interface Cards
Hardware Installation Guide that comes with every
card.
SLOT 1 Supports either a Cisco WIC or VIC. For detailed
information, refer to the Cisco WAN Interface Cards
Hardware Installation Guide that comes with every
card.
SLOT 2 Supports one Cisco VIC. For detailed information, refer
to the Cisco WAN Interface Cards Hardware
Installation Guide that comes with every card.
+5, +12, –12 Router connection to the external power supply.
VDC
Ground wire Router connection to earth ground by using a green and
yellow 14 AWG ground wire.
Rear Panel LEDs
Color Description
Green On—Ethernet port is operating in full-duplex mode.
Off—Ethernet port is operating in half-duplex mode.
Green On—Ethernet port is operating at 100 Mbps.
Off—Ethernet port is operating at 10 Mbps.
Green On when the Ethernet link is up.
Green On when either a WIC or VIC is correctly inserted in the
card slot.
Green On when either a WIC or VIC is correctly inserted in the
card slot.
Cisco 1750 Router Hardware Installation Guide
Rear-Panel Ports and LEDs
v