Pre-Installation; Tools Required; Hardware Required - Husky VT631404 Use And Care Manual

Pre-Installation

PLANNING INSTALLATION
WARNING: Disconnect, tag, and lock out the power source
before attempting to install or relocate the compressor.
IMPORTANT: This compressor is not intended for outdoor
installation.
It is extremely important to install the compressor in a clean, well ventilated area where the surrounding air temperature will not be more
than 100°F. Provide a minimum clearance of 18 in. between the compressor fl ywheel or fan and the wall, and ensure clear access to the
drain valve to facilitate condensate drainage. Do not locate the compressor air inlet near steam, paint spray, sandblast areas, or any other
source of contamination.

TOOLS REQUIRED

Claw hammer
Measuring
tape
Hammer drill
and masonry
bit

HARDWARE REQUIRED

NOTE: Hardware not shown to actual size.
Concrete wedge
anchors
Safety goggles
Adjustable
wrenches (2)
Voltage meter
Vibration isolation
set (3 metal plates
and 6 rubber pads)
7
Phillips
screwdriver
Ratchet and
1/2 in. socket
Work gloves
e
Please contact 1-888-43-HUSKY for further assistance.
Flat blade
screwdriver
Pipe wrench
Strain relief
HUSKYTOOLS.COM