Figure 42. Installing a drive carrier
Next steps
If removed,
replace the front
PERC module
Removing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the drive backplane
4. Disconnect all the cables from rear mounting front PERC module, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
2. Slide out the rear mounting front PERC module to disengage from the connector on the drive backplane.
bezel.
Safety
instructions.
Before working inside your
cover.
system.
Installing and removing system components
47