Table Of Contents - Broan EW4330SS Installation Use And Care Manual

Chimney range hood
Table of Contents

Advertisement

Available languages

Available languages

1. P
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
rePare installation
2. s
elect installation tyPe
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
4
i
(
(
-
ducted installation only
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
1. PREPARE INSTALLATION
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the retailer.
Make sure that the following items are included:
- Hood
- Hood mounting bracket
- Decorative flue assembly (lower and upper flues)
- Upper flue mounting bracket
- Aluminum grease filter(s)
(1 for 24-in. width hood, 2 for 30-in. and 36-in. width hoods)
- Installation instructions
- Parts bag: 9 no. 8 x 1½" Phillips flat head screws,
2 M4 x 12 Phillips round head screws,
2 washers,
3 wire connectors
Parts sold separately:
- Ducts, elbows, wall and roof caps.
- Optional flue extension for ceilings of 9 ft. or more: models AEEW43SS
(stainless steel) or AEEW43BLS (black stainless steel).
- Non-duct kit model ARKEW43, mandatory for non-ducted installation.
NOTE: During installation, protect countertop and/or cooktop.
2. SELECT INSTALLATION TYPE
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
2.1 N
-D
I
oN
ucteD
NstallatIoN
The ARKEW43 non-duct kit is required for a non-ducted installation.
2.2 D
I
ucteD
NstallatIoN
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to perform most efficiently. Long duct
runs, elbows and transitions will reduce the performance of the hood. Use as few of
them as possible. Larger ducting may be required for longer duct runs.
Install wall or roof cap. Connect 6" round metal ductwork to cap and work back
towards the hood location. Use 2" metal foil duct tape to seal the joints.
2.3 a
I
ll
NstallatIoNs
The minimum hood distance above cooktop is 24" . A maximum of 30" above
cooktop is recommended for best capture of cooking impurities.
Distances over 30" are at the installer and users discretion providing that ceiling
height and decorative flue length allow it.
NOTE: Ceilings of 9 ft. or more require flue extension model AEEW43SS (stainless
steel) or AEEW43BLS (black stainless steel).

TABLE OF CONTENTS

. . . . . . . . . . . . . . . . . . . . . . . . . 3
). . . . . . . . . . . . . . . . . . . . . . . . 4
) . . . . . . . . . 4
(
) . . . . . . . . . . . . . . . . . . . . . . . . . 5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
HR0267A
WARNING
! !
VQ0010
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
. . . . . . . . . . . . . . . . . . . . . . 8
. . . . . . . . . . . . . . . . . . . . . 8-9
(
) . . . . . . . . . . . . . . . . . . . . . . . 9
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
(1) D
ECORATIVE FLUE
ASSEMBLY
(1) H
OOD
MOUNTING BRACKET
R
OOF CAP
D
ECORATIVE
FLUE
H
OOD
24"
MINIMUM ABOVE
COOKING SURFACE
HH0282A
(1) U
PPER FLUE
MOUNTING BRACKET
(1
2) G
(
)
OR
REASE FILTER
S
(9) #8
1-1/2"
X
PHILLIPS
FLAT HEAD SCREWS
(2) M4
12 P
X
HILLIPS
ROUND HEAD SCREWS
(2) W
ASHERS
(3) W
IRE CONNECTORS
6" R
OUND
DUCT
W
ALL
CAP
6" R
OUND
ELBOW

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ew43 series

Table of Contents