Broan EW5630SS Manual
Broan EW5630SS Manual

Broan EW5630SS Manual

Chimney range hood
Hide thumbs Also See for EW5630SS:

Advertisement

Chimney

Range Hood

READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSON(S) OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the
address or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock service disconnecting means to prevent
power from being switch on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the service
panel.
3. Installation work and electrical wiring must be done by
qualified personnel in accordance with all applicable codes
and standards, including fire-rated construction codes and
standards.
4. Provide sufficient air for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the combustion equipment
standards such as those published by the National Fire
Protection Association (NFPA), the American Society for
Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE) and local codes.
5. This product may have sharp edges. Be careful to avoid cuts
and abrasions during installation and cleaning.
6.. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. Use only metal ductwork.
9. Do not use this unit with any other solid-state speed control
device.
10. This unit must be gounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
a) Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may
ignite. Heat oils slowly on low or medium settings.
b) Always turn hood ON when cooking at high heat or when
flambéing food (i.e. Crêpes Suzette, Cherries Jubilee,
Peppercorn Beef Flambé).
c) Clean ventilating fans frequently. Grease should not be
allowed to accumulate on fan or filters.
d) Use proper pan size. Always use cookware appropriate for
the size of the surface element.
TO REDUCE THE RISK OF INJURY TO PERSON(S) IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING*:
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet,
or metal tray, then turn off the burner. BE CAREFUL
TO PREVENT BURNS. IF THE FLAMES DO NOT GO
OUT IMMEDIATELY, EVACUATE AND CALL THE FIRE
DEPARTMENT.
FOR DOMESTIC COOKING ONLY
MODELS EW5630SS • EW5636SS
WARNING
2. NEVER PICK UP A FLAMING PAN – You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels – a
violent steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher, and you
know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Firesafety Tips" published by NFPA
CAUTION
1. For indoor use only.
2. For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
3. To avoid motor bearing damage and noisy and/or unbalanced
impeller, keep drywall spray, construction dust, etc. off power
unit.
4. Your hood motor has a thermal overload which will
automatically shut off the motor if it becomes overheated.
The motor will restart when it will cool down. If the motor
continues to shut off and restart, have the hood serviced.
5. The bottom of the hood MUST NOT BE LESS than 24" above
cooktop.
6. Two installers are recommended because of the size of this
hood.
7. To reduce risk of fire and to properly exhaust air, be sure to
duct air outside. Do not exhaust air into spaces within walls
or ceilings or into attics, crawl spaces, or garages.
8. Be careful when installing the decorative flue and hood, they
may have sharp edges.
9. This hood is not intended to be used as a shelf.
10. Please read specification label on product for further
information and requirements.
Register your product online at: www.broan.com
Installer: Leave this manual
with the homeowner.
Homeowner: Operation and Maintenance
instructions on page 2.
Page 1

Advertisement

Table of Contents
loading

Summary of Contents for Broan EW5630SS

  • Page 1: Range Hood

    Peppercorn Beef Flambé). c) Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filters. d) Use proper pan size. Always use cookware appropriate for Register your product online at: www.broan.com the size of the surface element. TO REDUCE THE RISK OF INJURY TO PERSON(S) IN THE Installer: Leave this manual...
  • Page 2: Measure The Installation

    MODELS EW5630SS • EW5636SS Page 2 MEASURE THE INSTALLATION PREPARE THE HOOD Unpack hood and check contents. You should receive: ROOF CAP 1 - Hood Assembly 1 - Glass Canopy ROUND ELBOW 6” 1 - Decorative Flue Assembly (consisting of upper and lower flue) ROUND DUCT WALL CAP 1 - Upper Flue Mounting Bracket DECORATIVE FLUE 1 - Aluminum Grease Filter (installed on hood) HOOD MOUNTING BRACKET 3¾” FROM WALL 2 - 35W R16 GU10 Halogen Lamps (installed on hood) TO CENTER LINE OF DUCT 1 - Parts Bag containing: ”...
  • Page 3: Install The Wiring

    MODELS EW5630SS • EW5636SS Page 3 INSTALL THE WIRING INSTALL THE HOOD MOUNTING SUPPORT H O O D C E N T E R L I N E 1 2 ” M A X . 5 ” ” M A X .
  • Page 4 MODELS EW5630SS • EW5636SS Page 4 INSTALL THE HOOD (Ducted Hoods Only) Flush with Center of Ceiling the ceiling installation Upper flue mounting bracket slots 6. Align the keyhole slots on the hood with the mounting screws 1. Center the flue mounting bracket over the hood location and that were partially tightened into the wall framing. Ensure that flush with the ceiling. Secure the upper flue bracket to the hood is seated entirely on mounting screws and that hood is wall using (2) #X x 1½” mounting screws.
  • Page 5: Install The Hood

    MODELS EW5630SS • EW5636SS Page 5 INSTALL THE HOOD 6” ROUND (Non-Ducted Hoods Only) STEEL DUCT DUCT LENGTH NON-DUCT KIT MODEL RKE56 CONTENTS DECORATIVE NON-DUCTED RECIRCULATION FLUE FILTERS FILTER TRAY NON-DUCT PLENUM ASSEMBLY 10. Measure and install steel ductwork to hood duct connector and ductwork rough-in on ceiling or wall. Use duct tape to make all joints secure and air tight. 4 MOUNTING 2 MOUNTING SCREWS 11. Plug power cord into wall outlet.
  • Page 6 MODELS EW5630SS • EW5636SS Page 6 9. Install (2) 4mm x 38mm long screws into the holes inside the hood and tighten them securely 4. Remove (3) screws holding electronics mounting bracket to hood. Rotate bracket 180 degrees and re-attach bracket to hood with same (3) screws. 10. Carefully place glass canopy on top of the hood. Align nuts 5. Remove the grease filter by pulling down the metal latch tab on glass canopy with holes inside the hood. Attach canopy and tilting filter downward to remove with (4) .188” x .250” long flat head screws. Tighten screws 6. Remove the protective plastic film covering the decorative securely but DO NOT OVERTIGHTEN. flue and the hood at this time. 7. Remove the grease filter by pulling down the metal latch tab and tilting filters downward to remove.
  • Page 7: Operation

    MODELS EW5630SS • EW5636SS Page 7 OPERATION NON-DUCT Always turn the hood ON before cooking in order to establish an air PLENUM 6” ROUND flow in the kitchen. After turning off the range, let the hood run for a FLEXIBLE few minutes to clear the air. METAL DUCT DUCT LENGTH Operate the hood as follows: DELAY OFF LIGHT DECORATIVE FLUE FAN SPEED LED INDICATORS 13. Measure and install section of flexible metal ductwork Turns the fan OFF (included with RKE56) to hood duct connector and bottom FAN (1-Pushbutton Switch, 3-Fan Speeds) of non-duct plenum. Use duct tape to make all joints secure Turns the fan ON to the last selected speed, and activates a blue LED and air tight.
  • Page 8: Cleaning And Maintenance

    LIGHT BULBS 1. Disconnect power at service entrance. 2. Remove decorative flues. 3. Remove control cover. 4. Remove and inspect fuse. SUCTION CUP TOOL MAKE-UP AIR DAMPER The hood is compatible with Broan Make-Up Air Damper Model MD6T or Model MD8T (optional). Purchase separately. HALOGEN PUSH IN MAKE UP DAMPER CONNECTION MAKE-UP AIR DAMPER BULB (switched low voltage) 20 GAUGE BELL WIRE FOR LOW...
  • Page 9: Service Parts

    BROAN-NUTONE ONE YEAR LIMITED WARRANTY Broan-NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one year from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

This manual is also suitable for:

Ew5636ss

Table of Contents