Page 1
WWW.BROAN.COM WW.BR WWW.BROAN.CA CHIMNEY RANGE HOOD EW46 Series INSTALLATION, USE AND CARE MANUAL Serial number: 99046143B...
Page 2
9. To reduce the risk of fire and electrical shock, the Broan Elite d) Use proper pan size. Always use cookware appropriate for the EW46 Series models should only be installed with their own size of the surface element.
3. BUILD FRAMEWORK WARNING • When cutting or drilling into wall, do not damage electrical wiring and other hidden utilities. • When building framework, always follow all applicable construction codes and standards. ALL STUDS Construct wood wall framing that is even with the surface of wall studs. Wood wall framing must be at least 1/2”...
6. REMOVE GREASE FILTERS Lay the back side of the hood flat on a table. Use a piece of cardboard to avoid damaging the table or the hood. To remove the grease filters, pull down on the metal latch tab and tilt each filter downward.
9. CONNECT WIRING WARNING Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting means to prevent power to be switched on accidentally. Detach the junction box cover from the top of the hood by removing both retaining screws.
10. DUCT CONNECTION ERTICALLY DUCTED INSTALLATION Slide a 6” round metal duct section over the adapter/damper on the hood up to the roof cap. Use metal foil duct tape to seal the joint. HJ0203 ORIZONTALLY DUCTED INSTALLATION Measure and install 6” round metal ductwork to wall cap and 90° elbow over duct collar then install the 90°...
11. PREPARE THE DECORATIVE FLUE CAUTION DO NOT REMOVE the protective plastic film covering the upper flue yet. NOTE: Both lower and upper flues are included with the hood, but for ceilings of 9 ft. or more, discard the provided lower and upper flues and use the optional flue extension, part no.
12. INSTALL THE DECORATIVE FLUE ( CONTINUED DUCTED INSTALLATION Slide up the upper flue until it is aligned with the plenum. Secure the upper flue to the plenum using 2 M4 x12 Phillips 9 mm round head screws. Remove protective plastic film covering the upper flue and the hood. HO0293 PPER FLUE MOUNTING BRACKET RONT VIEW...
14. OPERATION Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the blower run for a few minutes to clear the air after you turn off the range. This will help keep the whole kitchen cleaner and brighter. HC0088 1) Blower Speed key + OFF 2) Master ON/OFF key...
EPLACEMENT ARTS AND EPAIRS In order to ensure your unit remains in good working condition, you must use Broan- NuTone LLC or Venmar Ventilation ULC genuine replacement parts only. Broan-NuTone LLC or Venmar Ventilation ULC genuine replacement parts are specially designed for...
Company’s most current written limited warranty for your particular product will control. The most current limited written warranties for the Company’s products can be found at www.broan.com and www.broan.ca.