Directly Access Through Ie - Genie WIPX2LBVLPR User Manual

Network Camera User Manual
The system will pop up the above-mentioned textbox to ask you to change the default
password. It is strongly recommended to change the default password for account security. If
"Do not show again" is checked, the textbox will not appear next time.

2.1.2 Directly Access through IE

The default network settings are as shown below:
IP address: 192.168.226.201
Subnet Mask: 255.255.255.0
Gateway: 192.168.226.1
HTTP: 80
Data port: 9008
Use the above default settings when logging in the camera for the first time. Directly connect
the camera to the computer through network cable.
① Manually set the IP address of the PC and the network segment should be as the same as
the default settings of the IP camera. Open the network and share center. Click "Local Area
Connection" to pop up the following window.
Select "Properties" and then select internet protocol according to the actual situation (for
example: IPv4). Next, click the "Properties" button to set the network of the PC.
4