Alarm Server; Event Configuration - Genie WIPX2LBVLPR User Manual

Network Camera User Manual
Day/Night Switch Linkage: Having selected this mode, select the alarm type and then
choose to open or close alarm out when the camera switches to day mode or night mode.
Timing: Select the alarm type. Then click "Add" and drag the mouse on the timeline to set
the schedule of alarm out; click "Erase" and drag the mouse on the timeline to erase the set
time schedule. After this schedule is saved, the alarm out will be triggered in the specified
time.

4.4.5 Alarm Server

Go to AlarmAlarm Server interface as shown below.
Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the
camera will transfer the alarm event to the alarm server. If an alarm server is not needed, there
is no need to configure this section.

4.5 Event Configuration

For more accuracy, here are some recommendations for installation.

Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of
detection.

Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass,
lake surfaces and so on).

Do not aim the camera at the sun, road lamp or headlights of the car.

Avoid places that have too much shadowing.
26