Install The Water Inlet Hose - Haier XQS50-28 User Manual

Steps of using the operation buttons and description
of the steps
Push the "Power on/off " button to switch on the power.
2
Push the "program" button to select suitable automatic program.
After switching on the power, the machine will set standard program automatically. To select other automatic
program, push the "program" button till the relative indicator is on. Refer to the "program button" on Page
11 for the selection.
For instance: select "super quick" program for laundries with small
quantity and light soil.
In selecting the standard program, the machine
will execute fuzzy program to select water
and wash time according to the cloth and weight
of the laundries. The full procedure is controlled
automatically.
Push the "wash", "rinse" , "spin"or"TEMP wash/rinse" button to select suitable procedure.
Using process Using process
POWER
START
ON/OFF
PAUSE
PROGRAM
RESERVE
WATER LEVEL
POWER
ON/OFF
program
Page 11

Install the water inlet hose

Confirm the water faucet
water faucet, suitable
The exit end face of the faucet
It is required that the front end shall be longer than 10cm.
The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage.
Connection between the water inlet hose jointer and the water faucet
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the
water inlet hose component. See to Figure 1.
2 Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet.
See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen
the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth,
otherwise it may leak water. See to Figure 3.)
water inlet hose jointer
Slider
Lock level
Screw knife
water inlet hose
Figure 1
3.Fasten the four screws evenly. See to Figure 4.
4 Take off the nameplate. Twist the fastening nut as per the indication of the figure
to seal up the exit end face of the faucet. See to Figure 5.
remark: Before installation, the threading is 4mmabove the upper surface of the nut.
After installation, the threading is 2mm above the upper surface of the nut..
Figure 4 Figure 5
Before Using
Before Using
water faucet, not suitable
Screw
Sign plate
Bushing
Figure 2 Figure 3
About 4mm before twisting
About less than 2mm after twisting
Screw nut
Figure 6