Rack Mounting - HP Agilent 8757D Operating Manual

Rack Mounting

Use only the speci ed screws to install the rack mount kit. Longer screws can
Caution
damage internal components located behind the screw mounting holes.
ack Mounting without Front Handles
(Option 908)
Option 908 instruments are shipped with a rack mount kit. he kit supplies the hardware and
installation instructions to prepare the instrument to mount on an equipment rack with 482.6
mm (19 in) support spacing. o order additional rack mount kits, see able 1-4.
1. Refer to Figure 2-4. Contact your nearest sales and service oce. See able 1-5 for a list of
Agilent Oces.
2. Remove each front handle trim :
a. Insert the tip of a screwdriver between the back edge of trim and the front handle.
b. Pull forward.
3. Remove four screws
4. Attach one rack mount ange
5. Remove the feet and tilt stands
6. Save the at head screws and front handle assemblies for reuse.
ack Mounting with Front Handles
(Option 913)
Option 913 instruments are shipped with a rack mount kit. he kit supplies the hardware
and installation instructions to prepare a standard instrument (with handles) to mount on an
equipment rack with 482.6 mm (19 in) support spacing. o order additional rack mount kits,
see able 1-4. Contact your nearest sales and service oce. See able 1-5 for a list of Agilent
Oces.
1. Refer to Figure 2-4.
2. Remove each front handle trim :
a. Insert the tip of a screwdriver between the back edge of trim and the front handle.
b. Pull forward.
3. Remove four screws
4. Attach one rack mount ange
screws per side.
4
5. Remove the feet and tilt stands
6. Save the at head screws and front handle assemblies for reuse.
2-8 Installation
and one front handle assembly
4
with four panhead screws
2
.
5
and one front handle assembly
4
and one front handle assembly
2
.
5
per side.
3
per side.
4
per side.
3
with four panhead
3