Table of Contents
Advertisement
: HP-IB operates according to IEEE 488-1978 and IEC-625 interface standards. Note that
Interface
the HP-IB interface does not support the IEEE 488.2 standard.
Interface Function Codes
: You may transfer data either as ASCII characters, or as 16-bit integers (most
Transfer Formats
signi cant byte rst). You may take readings at a single point, or transfer an entire trace at once.
(includes command to initiate output):
Transfer peed
Programmable Functions
analyzer is compatible with all appropriate HP 8757A/C/E programming codes.
: The following conditions generate HP-IB service interrupts (SRQs):
Interrupts
The 8757 system interface is a dedicated HP-IB port used exclusively by the analyzer to control and
extract information from a swept source, digital plotter, printer, or other device.
:
Temperature Range
Maximum relative humidity 80% for temperatures up to 31 C decreasing linearly to 50%
Humidity:
relative humidity at 40 C (unless speci ed otherwise).
: 3000 meters
Altitude
: 48 to 66 Hz, 100/120/220/240 V 10%, typically 155 VA.
Power Requirements
: 178 x 425 x 445 mm (7.0 x 16.75 x 17.5 in).
Dimensions
:
Weight
1
The values in this table are
1-16 General Information
Table 1-3. Operating Characteristics 1 (4 of 4)
: SH1, AH1, T6, TE0, L4, LE0, SR1, RL1, PP0, DC1, DT0, C0, E1.
Format
ASCII
ASCII
Binary
Binary
: Except for power on/o , all front panel functions are programmable. The
Front panel key pressed
Instrument self-test error
Operation (sweep or plot) completes
ystem Interface
General
Operating:
Storage:
Net:
Shipping:
ot
speci cations, but typical, non-warranted performance parameters.
HP-IB
# Points
401
1
401
1
0 to +55 C (+32 to 131 F)
0 40 to +70 C ( 0 40 to +158 F)
17 kg (38 lb)
25 kg (55 lb)
(typical)
ms
500
10
30
7
Illegal command
Limit test fails
Advertisement
Table of Contents
